Wrench.Pro

2000 Daewoo NUBIRA Recalls, Problems & Maintenance

The 2000 Daewoo NUBIRA carries 3 open NHTSA recalls — most recently covering engine and engine cooling. Owners report 5 recurring issue clusters, led by “Camshaft position sensor recall: no dealer or parts.” Daewoo sold cars in the US for barely three years, and the surviving maintenance story comes down to one item: every US Daewoo engine is an interference design with a timing belt, and a snapped belt bends valves. The book says 60,000 miles on the Lanos and 72,000 on the Nubira and Leganza, but the Nubira's tensioner is famous in the owner community for loosening around 50,000, so the smart play on any of them is belt, tensioner, and water pump by 60,000, or on age for a car this old. The rest is ordinary 1990s GM-adjacent care on short intervals. Parts are more findable than you would guess; the Lanos engine family lived on under GM in the Chevy Aveo.

Save this car as:

3 Open Recalls

Source: NHTSA

ENGINE AND ENGINE COOLING

Campaign #04V357000 · Jul 14, 2004

Issue: ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.

Risk: THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.

Fix: DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. THE RECALL BEGAN ON SEPTEMBER 7, 2004. OWNERS SHOULD CONTACT DAEWOO AT 1-877-362-1234, OPTION 6, OR FIND A LOCAL DEALER THROUGH THEIR WEBSITE AT WWW.DAEWOOUS.COM.

ENGINE AND ENGINE COOLING

Campaign #04V394000 · Jun 8, 2004

Issue: ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.

Risk: THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.

Fix: DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. OWNERS SHOULD CONTACT DAEWOO PUERTO RICO AT 1-877-362-1234 OPTION 6.

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS

Campaign #02V257000 · Sep 18, 2002

Issue: CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 106, "BRAKE HOSES." A CRACK CAN DEVELOP IN THE OUTER RUBBER LAYER OF THE FRONT BRAKE HOSE(S).

Risk: THIS CAN RESULT IN BRAKE HOSE RUPTURE, BRAKE FLUID LEAKAGE, AND LOSS OF VEHICLE BRAKING.

Fix: DEALERS WILL INSTALL NEW REDESIGNED FRONT BRAKE HOSES. OWNER NOTIFICATION BEGAN OCTOBER 27, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAEWOO AT 1-877-362-1234, SELECTION 1.

Recall data refreshed Jul 26, 2026.

Known issues & problems for this vehicle

What drivers and federal regulators have officially reported about the 2000 Daewoo NUBIRA.

Reported to NHTSA

Camshaft position sensor recall: no dealer or parts

ENGINE AND ENGINE COOLING

95 NHTSA complaints · 2004-09 → 2005-01

“THE CONSUMER RECEIVED, NHTSA RECALL CAMPAIGN LETTER #04V357000 REGARDING THE CAMSHAFT POSITION SENSOR. THE COMPANY WAS OUT BUSINESS. NO DEALERSHIP AVAILABLE”
— Owner report, NHTSA ODI #10092371
“CONSUMER RECEIVED NHTSA RECALL 04V357000 CONCERNING CAM SHAFT POSITION SENSOR. NO PARTS WERE AVAILABLE”
— Owner report, NHTSA ODI #10097641
“THE CONSUMER WAS UNABLE TO FIND A DEALERSHIP OR CONTACT THE NUMBER PROVIDED ON THE RECALL LETTER FOR DAEWOO CUSTOMER SERVICE”
— Owner report, NHTSA ODI #10094177

Read all complaints on NHTSA →

Camshaft position sensor recall repair refused or charged

ENGINE AND ENGINE COOLING

28 NHTSA complaints · 2004-09 → 2006-06

“THE DEALERSHIP REFUSED TO HONOR THE CAMSHAFT POSITION SENSOR RECALL 04V357000 BECAUSE THEY INDICATED THAT THE SERIAL NUMBER ON THE PART DID NOT FALL WITHIN THE RECALL RANGE”
— Owner report, NHTSA ODI #10097270
“RECALL 04V357000 REGARDING CAM SHAFT POSITION SENSOR. DEALER CHARGED THE CONSUMER $79.97 FOR CAM SHAFT POSITION SENSOR REPAIRS”
— Owner report, NHTSA ODI #10097461
“CONSUMER RECEIVED 04V357000 CONCERNING CAM SHAFT POSITION SENSOR FROM THE MANUFACTURER. CONSUMER TOOK THE VEHICLE TO THE DEALER, AND WAS TOLD EVEN AFTER SHOWING THE RECALL NOTICE, THAT THIS VEHICLE DID NOT QUALIFY DUE TO VIN”
— Owner report, NHTSA ODI #10094116

Read all complaints on NHTSA →

Check engine light on with camshaft position sensor recall

ENGINE AND ENGINE COOLING

17 NHTSA complaints · 2004-09 → 2004-12

“WHILE DRIVING, THE CHECK ENGINE LIGHT APPEARED ON THE DASHBOARD AND REMAINED ON”
— Owner report, NHTSA ODI #10094222
“CHECK ENGINE LIGHT APPEARED ON THE DASHBOARD AND REMAINED ON. VEHICLE WAS RUNNING HARD/ROUGH, AND IDLED HIGH”
— Owner report, NHTSA ODI #10091629
“CHECK ENGINE LIGHT WARNING LIGHT WOULD ILLUMINATE WHILE DRIVING AND INTERMITTENTLY OVER HEAT WHILE DRIVING”
— Owner report, NHTSA ODI #10092114

Read all complaints on NHTSA →

Brake hose recall repair unavailable

SERVICE BRAKES, HYDRAULIC

19 NHTSA complaints · 2004-09 → 2004-12

“THE CONSUMER RECEIVED NHTSA RECALL 02V257000 ON THE FMVSS 106/ BRAKE HOSES. THE CONSUMER WAS UNABLE TO LOCATE A DEALER TO HONOR THE RECALL”
— Owner report, NHTSA ODI #10099068
“CONSUMER RECEIVED RECALL 02V257001 CONCERNING BRAKE HOSE. DEALER WAS NOT IN OPERATION”
— Owner report, NHTSA ODI #10097902
“CONSUMER RECEIVED NHTSA RECALL 02V257000 ON THE FMVSS 106/ BRAKE HOSES. THERE WERE NO PARTS AVAILABLE”
— Owner report, NHTSA ODI #10099072

Read all complaints on NHTSA →

Front control arm and bushing wear

SUSPENSION

12 NHTSA complaints · 2004-04 → 2005-07

“THE FRONT CONTROL ARM BUSHINGS WORE OUT AT 27, 000 MILES. AS A RESULT, WHEN APPLYING THE BRAKES A LOUD SQUEAKING NOISE WAS PRODUCED”
— Owner report, NHTSA ODI #10117106
“WHEN ACCELERATING FROM A STOP POSITION OR ACCELERATING WHILE IN MOTION AT 45-60 MPH VEHICLE PULLED TO THE LEFT”
— Owner report, NHTSA ODI #10099947
“WHILE DRIVING THE CONTROL ARM/ UPPER ARM FAILED”
— Owner report, NHTSA ODI #10063197

Read all complaints on NHTSA →

Issues on other model years

Source: NHTSA Office of Defects Investigation (ODI). Complaint data refreshed Sep 20, 2026.

We display NHTSA's record with attribution; we don't editorialize on what these complaints mean for any specific vehicle.

Raw data + downloads for this vehicle →

Essential maintenance

Critical for safety and preventing major damage

Timing Belt

Every 60,000 mi

The item that decides these engines' fate. Lanos 1.6: 60,000 miles. Nubira 2.0 and Leganza 2.2: 72,000 on paper, 60,000 in practice because of the Nubira's documented tensioner weakness. Do tensioner and water pump with it, and go by age if history is unknown; every one of these engines bends valves on failure.

Estimated cost — typical U.S. ranges

Dealer

~$935–$1175

Shop

~$655–$825

DIY

Pro only

On interference engines, a snapped belt destroys valves. Worth doing on schedule. Bundle water pump + tensioner — labor is already there.

Oil & Filter Change

Every 3,000 mi

The manual's severe schedule, 3,000 miles or 3 months, is the verified figure and the right one for short-trip use. Normal-schedule cars of the era ran about 7,500 or 12 months.

Estimated cost — typical U.S. ranges

Dealer

~$120–$160

Shop

~$85–$115

DIY

~$25–$55

Full synthetic costs more than conventional. 5-quart 0W-20 + filter is the typical bill.

Annual Inspection

Every 7,500 mi

Annual look over belts, hoses, cooling system, and suspension. Twenty-plus-year-old rubber fails on age, not miles.

Estimated cost — typical U.S. ranges

Dealer

~$85

Shop

~$60

DIY

Free

Most shops do this free with any paid service. A flashlight and 10 minutes covers the basics yourself.

Brake Fluid

Every 24,000 mi

Every 2 years is sound practice for the era; no verified factory interval survives.

Estimated cost — typical U.S. ranges

Dealer

~$180–$200

Shop

~$125–$140

DIY

~$10–$25

DOT 3 or 4 — match the cap. Vacuum bleeders make this a one-person DIY.

Tire Rotation

Every 7,500 mi

With each oil service.

Estimated cost — typical U.S. ranges

Dealer

~$85

Shop

~$60

DIY

Free

Often free at the shop where you bought the tires — worth asking before paying.

Important maintenance

Keeps your vehicle running smoothly and efficiently

Spark Plugs

Every 30,000 mi

Roughly every 30,000 miles for era-typical conventional plugs; no verified Daewoo-specific figure survives.

Estimated cost — typical U.S. ranges

Dealer

~$285–$390

Shop

~$200–$275

DIY

~$25–$100

Iridium plugs cost more but last 100k+ miles. V6/V8 access varies wildly — some are tough.

Recommended maintenance

Extends the life of your vehicle and improves comfort

Engine Coolant

Every 30,000 mi

Every 2 to 3 years with era-appropriate coolant. Cooling-system neglect is what killed most of these cars.

Estimated cost — typical U.S. ranges

Dealer

~$285–$330

Shop

~$200–$235

DIY

~$25–$60

Use the manufacturer-specified coolant — wrong color/chemistry can damage the cooling system.

Engine Air Filter

Every 30,000 mi

About every 30,000 miles, inspected at services.

Estimated cost — typical U.S. ranges

Dealer

~$60–$95

Shop

~$45–$70

DIY

~$15–$40

5-minute job on most cars; the airbox lid usually has clips, no tools needed.

Transmission Fluid

Every 30,000 mi

Every 30,000 miles is the safe habit for the era automatics; no verified factory figure survives.

Estimated cost — typical U.S. ranges

Dealer

~$330–$500

Shop

~$235–$355

DIY

~$60–$180

Some sealed transmissions have no dipstick — fill is precise and best left to a shop. Many drivers can still DIY drain-and-fill.

Typical U.S. ranges. Actual quotes vary by shop, parts choice, and vehicle condition.

How we estimate: Dealer = OEM parts × 1.4 + labor × $165/hr. Shop = parts + labor × $115/hr. DIY = parts only.

This maintenance schedule for the 2000 Daewoo NUBIRA reflects Daewoo's published service intervals. Your actual service needs may vary based on driving conditions, climate, and vehicle usage. Always consult your owner's manual for model-specific recommendations.

Check another vehicle →