Llamados a Revisión, Fallas y Mantenimiento del Oldsmobile Intrigue 2000

Problema: This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on July 3, 2014, that they are recalling 5,877,718 model year 2000-2005 Chevrolet Impala and Monte Carlo, 1997-2003 Chevrolet Malibu, 2004-2005 Malibu Classic, 1999-2004 Oldsmobile Alero, 1998-2002 Oldsmobile Intrigue, 1999-2005 Pontiac Grand Am and 2004-2008 Pontiac Grand Prix vehicles. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine.

Riesgo: If the key is not in the run position, the air bags may not deploy if the vehicle is involved in a crash, increasing the risk of injury.

Solución: GM will notify owners, and dealers will install two key rings and an insert in the key slot or a cover over the key head on all ignition keys, free of charge. The recall began on September 9, 2014. GM's number for this recall is 14350.

Problema: DORMAN IS RECALLING 979 STEERING KNUCKLES, DORMAN P/NOS. 697-902 AND 697-903, SOLD UNDER DORMAN'S "OE SOLUTIONS<SUP>TM</SUP>" BRAND NAME, AND NAPA P/NOS. 7-8502 AND 7-8503 WHICH WERE SOLD FOR REPLACEMENT USE ON THE VARIOUS VEHICLES LISTED ABOVE. A POTENTIAL MATERIAL OR DESIGN DEFECT COULD RESULT IN THE STEERING KNUCKLE BREAKING IN THE HUB AREA.

Riesgo: A BROKEN STEERING KNUCKLE COULD RESULT IN LOSS OF STEERING CONTROL AND A POSSIBLE CRASH WITHOUT WARNING.

Solución: DORMAN WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE STEERING KNUCKLES FREE OF CHARGE AND REIMBURSE THE REPAIR FACILITY OR OWNER FOR LABOR. THE RECALL BEGAN ON FEBRUARY 23, 2009. OWNERS MAY CONTACT DORMAN'S TOLL-FREE HOTLINE AT 1-800-523-2492 AND PRESS 5.

Problema: DORMAN PRODUCTS IS RECALLING 3,900 INTERMEDIATE STEERING SHAFTS DORMAN PART NOS. 425-151, 425-152, AND 425-153, (SOLD UNDER DORMAN'S "OE SOLUTIONS" BRAND NAME), BALKAMP #'S 7-3057, 7-3058, 7-3059 (SOLD UNDER THE "NAPA" BRAND NAME), AND PLATINUM PARTS #'S 2425151, 2425152, AND 2425153 MANUFACTURED DURING THE MONTH OF SEPTEMBER 2007. THESE REPLACEMENT STEERING SHAFTS CAN BE USED ON THE VEHICLES LISTED ABOVE. THE WELD CONNECTING THE INNER TUBE TO THE OUTER TUBE MAY BE DEFECTIVE.

Riesgo: IF THE WELD FAILS, LOSS OF STEERING COULD RESULT, POSSIBLY RESULTING IN A VEHICLE CRASH.

Solución: DORMAN WILL NOTIFY OWNERS AND REPLACE THE STEERING SHAFTS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 16, 2008. OWNERS MAY CONTACT DORMAN TOLL FREE AT 1-800-523-2492.

Problema: VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES, EQUIPPED WITH SUNVISOR LOCATED AIR BAG LABELS, FAIL TO CONFORM TO FEDERAL MOTOR VEHICLES SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." THESE VEHICLES HAVE A MESSAGE AREA LESS THAN 30 CM WHICH DOES NOT MEET THE REQUIREMENTS OF THE STANDARD.

Riesgo: THESE VEHICLES DO NOT COMPLY WITH THE STANDARD.

Solución: GM WILL MAIL A NEW BILINGUAL AIR BAG LABEL WITH INSTALLATION INSTRUCTIONS. HOWEVER, THE CUSTOMER MAY BRING THE LABEL TO THEIR DEALER FOR INSTALLATION FREE OF CHARGE. OWNER NOTIFICATION BEGAN MAY 4, 2001. OWNERS WHO DO NOT RECEIVE THE FREE LABEL AND INSTALLATION INSTRUCTIONS WITHIN A REASONABLE TIME SHOULD CONTACT OLDSMOBILE AT 1-800-442-6537 OR BUICK AT 1-800-521-7300.

Problema: VEHICLE DESCRIPTION: PASSENGER VEHICLES. SOME OF THESE VEHICLES HAVE INTERNAL FLUID LEAKS IN THE BRAKE HYDRAULIC CONTROL UNIT.

Riesgo: WHEN THE REAR BRAKE PROPORTIONING, ANTILOCK BRAKE, TRACTION CONTROL, OR STABILITY CONTROL FEATURE IS ACTIVATED IN SOME DRIVING SITUATIONS, THE FEATURE MAY NOT PERFORM AS DESIGNED.

Solución: DEALERS WILL INSPECT THE ABS HYDRAULIC MODULATOR UNIT AND IF NECESSARY, REPLACE THE HYDRAULIC MODULATOR.

Problema: VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."

Riesgo: IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANT MAY NOT BE PROPERLY RESTRAINED.

Solución: DEALERS WILL INSPECT THE VEHICLE'S SAFETY BELT BUCKLE ASSEMBLY DATE CODES AND, IF NECESSARY, WILL REPLACE ANY SAFETY BELT BUCKLE ASSEMBLY.